ULTIMA 700 ULTIMA RS850 Temperature Range Max service temperature +110˚C (for temperatures above +110˚C please contact our technical department) +70˚C Min service temperature -50˚C (for temperatures below -50 ˚C please contact our technical department) -40˚C (for temperatures below -40 ˚C please contact our technical department) Performance Coverage (guidance only) Minimum consumption with the adhesive applied to both surfaces: ArmaFlex tubes (thickness > consumption unslit > consumption slit) • 10mm > 1,120m per litre > 140m per litre • 20mm > 280m per litre > 70m per litre • 30mm > 175m per litre > 45m per litre • 40mm > 130m per litre > 35m per litre Sheets • 3-4 m2 perlitre Storage & shelf life 12 months in an unopened container. Store as cool as possible but protected from frost. In the event of frost any gelification is reversible on warming 18 months in an unopened container. Store between 0˚C and 35˚C in a dry place. Do not store with explosive substances or spontaneously combusting substances. In the event of frost any gelling is reversible on warming ARMAFLEX ULTIMA 700 One-component adhesive specifically developed for ArmaFlex Ultima and insulating materials based on Armaprene® synthetic rubbers. Material type Contact adhesive on polychloroprene basis, free of aromatic components. Colour Blue Applications Application on pipes and tanks with service temperature up to +110˚C. Gluing of ArmaFlex Ultima and insulation materials based on Armaprene® synthetic rubbers. Assembly Please observe our installation instructions/product data sheets. Application temperature: ideally +15˚C to +20˚C, not below 0˚C. At temperatures below +5˚C or high humidity approx above 80%), increased condensation may form on the surfaces to be glued or adhesive films. In these cases bonding is poor or impossible. This can be tested by using absorbent paper (blotting or crepe paper). Work should not be carried out on operating plant or areas expossed to strong sunlight. Remarks The adhesive achieves its final strength after 36 hours. Only then should plant be put into operation. Wait 36 hours before applying coatings (exception: Armafinish 99), adhesive tape, coverings etc. ARMAFLEX ULTIMA RS850 Non-drip one component adhesive gel form. Specifically designed for processing ArmaFlex and insulating materials based on Armaprene® synthetic rubbers Material type Thixotropic one component contact adhesive based on polychloroprene. Colour Blue Material special information Gel based Applications Application on pipes and tanks with service temperature up to +70˚C. Gluing of ArmaFlex Ultima and insulation materials based on Armaprene® synthetic rubbers. Assembly Please observe our installation instructions/product data sheets. Application temperature: ideally +15˚C to +20˚C, not below +10˚C. At temperatures below +5˚C or high humidity approx above 80%), increased condensation may form on the surfaces to be glued or adhesive films. In these cases bonding is bad or impossible. This can be tested by using absorbent paper (blotting or crepe paper). Work should not be carried out on operating plant or areas expossed to strong sunlight. Remarks The adhesive achieves its final strength after 24 hours. The system should not be operated during this period and any self-adhesive tape or protective coatings should only be applied after this period has elapsed. TECHNICAL DATA 231