ARMAFLEX HT625 One-component adhesive for high temperature applications, specifically developed for HT/ArmaFlex installations but also suitable for all ArmaFlex synthetic rubber based insulation materials. Material type Contact adhesive on polychloroprene basis, free of aromatic components. Colour Beige Material special info Liquid Applications Application on pipes and tanks with service temperature up to +150˚C. Gluing of HT/ArmaFlex insulation materials and other ArmaFlex synthetic rubber based insulation materials (except ArmaFlex Ultima). Special features Specially formulated adhesive for uniform and safe seam bonding of ArmaFlex insulation materials applied on high temperature lines. Assembly Please observe our installation instructions/product data sheets. Application temperature: ideally +20˚C, not below 0˚C. At temperatures below +5˚C or high humidity approx above 80%), increased condensation may form on the surfaces to be glued or adhesive films. In these cases bonding is poor or impossible. This can be tested by using absorbent paper (blotting or crepe paper). Work should not be carried out on operating plant or areas exposed to strong sunlight. Remarks The adhesive achieves its final strength after 36 hours. Only then should plant be put into operation. Wait 36 hours before applying coatings (exception: ArmaFinish 99), adhesive tape, coverings etc. ArmaFlex HT625 adhesive • Specially formulated for a wide range of temperatures and applications • Water-tight bonding of HT/ArmaFlex® and ArmaFlex® DuoSolar insulation systems • For operating temperatures up to +150 °C • High performance, one component industrial grade adhesive • Low-viscosity air-drying contact adhesive THE HIGH TEMPERATURE ADHESIVE FOR USE WITH HT/ARMAFLEX 109